DANTE VIRTUAL SOUNDCARD DANTE CONTROLLER SOFTWARE
This is necessary so IRIS software knows which signals are arriving from the microphone array, and where to send the excitation signal to the loudspeaker.ĭante Controller does not have to be running once the network is configured as the routing information is stored on each device in the Dante network. Dante Controller ¶ĭante Controller software is used to configure the routing of audio signals between different devices on a Dante network. Low latency is not important for an IRIS measurement, and IRIS will automatically compensate for any latencies in the Dante network and Dante ASIO driver.
If you experience any issues with audio glitching during a measurement (a gap or click during sweep playback), try setting larger buffer sizes and a longer latency (ASIO latency and Dante latency). However, please check that it is running each time you set up your IRIS system.
DANTE VIRTUAL SOUNDCARD DANTE CONTROLLER PC
Your PC should remember these settings, and the DVS will remain active unless you click Stop. The virtual soundcard will remain active.Īn example of Dante Virtual Soundcard configuration: Most PCs only have one wired Ethernet connection.Ĭlick Start to enable the virtual soundcard. Specify which network adapter your laptop is using to connect to the Dante network. The Dante Virtual Soundcard allows IRIS to send and receive audio on the Dante network using ASIO drivers. Dante Network Configuration ¶ Dante Virtual Soundcard (DVS) ¶ You should see some activity on the level meters if you make some noise. The final configuration should look like this (click on the screenshot for a clearer view). The other settings can be ignored ( Digital Gain set to 0 dB, and Mute switches disabled) Set the Analog Gain (dB) to 30 on all 4 channels. It will list the Shure devices on any Dante networks with your PC.ĭouble click on the ANI4IN-XLR entry to open the configuration web page for this device. Open the Shure Web Device Discovery software. The preamp will remember its internal settings but please check each time you set up IRIS. The Shure preamp needs to be configured with the correct settings for use with IRIS. The connected switch in the base of the case may look like this: The switch has a built-in 100-240 V power supply with IEC connector.
0 kommentar(er)
